Conduit Benders DOBLADOR DE TUBO DUCTON/EMT 弯管器

 Threaded gray aluminum short radius bender heads are used on 1/2" EMT pipes to bend conduits in many shapes so wire can be run to destination appliances needing electric power. Garvin Industries’ conduit benders have a non-slip, contoured pedal design to provide additional leverage in installation. They have cast-in markings for stub-ups, saddle bends, back-to-back bends, and head-up or down bending. They also have a strong, stable square hook design.

Conduit Bender (With Stick)
Bitmap	1/2"	aluminum, EMT 1/2"
	3/4"	aluminum, EMT 3/4", Rigid 1/2"
	1"	aluminum, EMT 1", Rigid 3/4"

Wire Pulling and Conduit Installation 
Garvin Industries manufactures a variety of wire pulling aids like polyolefin twine in a bucket, polypropylene rope, and nylon pull tape with sequential foot markings and a prelubricated surface that easily glides through conduits and inner duct.  Innovative synthetic fibers of these pull lines and tapes will not rot, rust, or mildew if they are left in conduit for extended periods of time.  Garvin Industries also manufactures conduit bender heads and handles, as will as pipe marking tools for 1/2" or 3/4" conduit.
Conduit Benders & Pipe Marking Tools   
Application:
These conduit benders are used on EMT pipes to create bends in many shapes so wiring can be run to destination appliances requiring electric power. 
Advantages::
Garvin Industries’ conduit benders have a non-slip, contoured pedal design to provide additional leverage during use. They have cast-in markings for stub-ups, saddle bends, back-to-back bends, and head-up or down bending. They also have a strong, stable square-hook design. 

 《产品实图》

《我们生产的所有产品》

《厂区》

 
《办公区》

 
《产品原料》

《工厂车间》

《产品装配》

 
《产品包装》

 
《工厂出货》

《广交会》

《工厂荣誉》